Considerations To Know About imr 4350 load data

Considerations To Know About imr 4350 load data

Blog Article

As for all other powders, both have an issue with them not being able to stay under working pressures at around 1300fps since they've a a lot quicker melt away rate that St marks 296, or burn off so incredibly hot that They simply melt away up the hulls promptly isntead.



Will not understand about 410, but, I ran into the same matter with Alliant e3. I started taking pictures it in .forty S&W and in many cases despatched take a look at loads to Alliant for stress screening with very good success.

As to migrating 296, I make use of the Spolar furnished rubber gromet down below an following market place pyrodex powder tube from SGW member skeeljc and there is very little powder migration with my #405 Spolar.

Dano523 claimed: Only difficulty with not reaming the shot bushing to toss 226 of shot inside a HS hull with .296" powder bushing, would be the shot is going to rattle within the shell (my Variation of a follow only load In case the shot rattles once you shake the spherical). Click to expand...

I concur, You should not run off reaming anything at all right until you've got loaded sufficient for being confident with your stack height.

If That is your first take a look at, be sure to look into the FAQ by clicking the hyperlink previously mentioned. You will have to sign-up prior to deciding to can write-up: click on the sign up backlink over to proceed.




We're engineers, reloading fanatics and run Probably the most powerful ballistics calculators.

So Should your not intending to ream the shot bushing and just Enable it throw 214grs of shot, then up the powder bushing to your .three hundred" ID bushing inside the HS loads. This extra little little bit of powder will provide the shell the necessary quantity to fill it fully, so the shot isn't going to rattle after crimp.

Now Then again, In the event the hulls are HS, then the powder bushing you need will have an ID of .296" plus my site a target bodyweight fall of 16.9grs, which must put the shell around 1325fps, and that will pattern a hell of good deal better than one particular at 1200fps isntead.

0   Reply This really is an more mature thread, you may not get a reaction, and will be reviving an old thread. Be sure to consider creating a new thread.

Alliant Powder’s new 410 flake powder is the one flake powder notably customized for the stringent needs of.

Aviso Legal




Despite the fact that I have not tried out it discover this info here I concur along with your contemplating over a 4 ball load, looks like exactly the same dilemma as I Formerly pointed out using a five pellet load of OOO buck.

The shell are definetly less than powered. All over again I'm working with Alliant Green Dot powder as proposed from other forums which i browse. I'm open up to any strategies or assistance on these loads.